PA2 is a SIP video intercom & Paging device for industry application. The media stream transmission adopts standard IP/RTP/RTSP protocol. It inherits the advantages of the stability and the sound quality of FANVIL VOIP Phone. It is perfectly compatible with all the current SIP IPPBX /IMS platforms, such as Asterisk, Broadsoft, 3CX, Elastix, etc. It has various functions and interfaces, Such as Intercom, broadcast, video , security, recording, to adapt different application environment, you can very easy to DIY your video intercom & paging equipment. PA2 is the best choice for everyone.
Highlights:
Small and exquisite, can be embedded in the internal installation
Emergency call button interface, active call
Interact with IPC camera, you can make a video phone call
NVR video recording, standard RJ45 interface
Recording output, 3.5mm standard audio interface
10W-30W adaptive output power
System online management and upgrade
Intercom:
Two SIP lines, supporting SIP 2.0 (RFC3261) and related RFC
Supports two lines RTSP
Voice broadcast IP address Button or remote volume adjustment
Switch signal input and output
Talkback recording output
Handsfree talking
Default auto answer ? Dynamic multicast function ? Supports DC or POE power supply
Support for Function key interface ? Support monophonic active speakers ? Network time synchronization ? Action URL / Active URI remote control
Audio:
Narrowband speech coding: G.711a / u, G.723.1, G.726-32K, G.729AB
Broadband speech coding: G.722
Half Duplex Echo Cancellation (AEC)
DTMF: In-band, out-of-band DTMF (RFC2833) / SIP Info Networking/ Protocols
Supports PoE (802.3af)
Primary and secondary DNS servers are supported
Support VLAN
Supports SNTP client
Support VPN L2TP / PPTP / IPSec Supports SRTP
Support for HTTP / HTTPS web pages ? Support Qos: 802.1p / q, DSCP
Support MD5 authentication ? Supports Web Filter ? DHCP / static / PPPoE
STUN
Physical Specifications:
2 RJ45 interface: Yellow: WAN port 10 / 100M adaptive, support POE PoE: 802.3af (Class 3: 6.49 ~ 12.95W) Black: LAN port (Only connected to the original camera) Cable: Super five lines or better ? 1 blue indicator (SIP status and network status)
2 volume plus or minus key
1 restore factory settings key
1 recording output interface: 3.5mm standard audio interface 15 Ohm impedance ? 1 ground screw ? 1 way passive speaker interface: Output power: 4Ω, POE / 10W, 12V /10W,18V / 20W, 24V / 30W; related to supply voltage. Wire diameter: 18 AWG or larger diameter Interface:Pluggable terminal block
1 way microphone input interface: Recommendation: Use an electret condenser microphone Sensitivity: -38dB, Impedance 2.2 K Ohm bias voltage 2.2V Interface:Pluggable terminal block
1 short circuit input and output interface (built-in relay): Relay: MAX DC30V /1A, AC125V/0.5A, Interface:pluggable terminal block
2 parallel power input interface: 12V-24V / 2A DC 1 road for the 5.5mm DC power seat 1 road way 2Pin pluggable terminal block
Standby power consumption: DC12V 1.32W / POE 1.78W