HyperLink GT series are high power indoor RF amplifiers for 2.4 GHz spread spectrum wireless LANs. High power and excellent linearity make it the highest performance wireless LAN amplifiers available today. These WiFi amplifiers are compatible with 802.11b/g/n wireless LAN equipment. HyperLink's APC (Active Power Control) circuit automatically adjusts the amplifier's gain to provide a constant output power regardless of cable length. Consisting of a receive amplifier and a transmit power amplifier, the GT series installs indoors near the radio itself, combining ease of installation with significant improvement in operating range and performance.
The "GT" series WiFi amplifiers increase range by providing transmit gain as well as 15 dB of receive gain. This receive gain actually increases the receive sensitivity of most wireless LAN radios. This unit can be configured to deliver full transmit power with as little as 1 mW of input power. This feature permits cable runs of several hundred feet with no degradation in operating range.
Our design features 32W FET allowing these amplifiers to deliver full rated linear output in 802.11g mode.
The GT amplifier features a heavy-duty enclosure machined from a single block of aluminum making it suitable for demanding commercial and military applications. Included with the amplifier is a 12 VDC @10.8A (130W) power supply.
The HA2410GT-KIT is ideal for outdoor applications. Along with the amplifier, it features a 14"x12"x7" weatherproof enclosure with a thermostat controlled cooling fan. These enclosures feature fiberglass construction, stainless steel quick release latches with padlock hasps and integral mounting flange. Each outdoor amp kit includes:
Weatherproof Fiberglass Enclosure with Thermostat Controlled Cooling Fan
Aluminum Mounting Plate for 12 VDC Operation
12 in. DC Jumper Cable (connects amp to power terminal strip)
(2) N-Male Right Angle to N-Male 2 ft. Pigtail Cables
(2) N-Female to N-Female Bulkhead Lightning Surge Protectors
2-Position Terminal Block (connects power supply to 10 AWG cable)
Note: These enclosures can also be purchased separately
This HyperLink bi-directional amplifier is designed for burst half-duplex operation. It is not intended for constant transmit or CW operation. Operation of the amplifier in CW mode will damage the amplifier and void the warranty. Also note the following warnings, the maximum VSWR (antenna, cable assembly, connectors, etc) coming into and out of the amplifier is 1.5:1 and the maximum input power is 100 mW.